Boise Water Heater Maintenance in 10 Minutes

Posted by on Feb 25, 2014 in Water Heater Repair Boise

We are going to put you to work today, however just for about 10 minutes. Yep, that’s all it will consider these two vital water heater upkeep jobs; nevertheless, Water Heater Repair Boise¬†understands they will do an exceptional task of helping with three things:
Having your water heater last as long as possible (that will save you money).
Making sure the water heater runs safely (we do not desire it to explode).
Having it run as energy efficiently as possible (likewise saving you cash).

So with that in mind, are you ready to spend 10 minutes once or two times a year to assist in saving some money? Water Heater Repair Boise ID thought so.

Testing the T&P Relief Valve

Typically called the T&P Valve, or the temperature and pressure relief valve, has a crucial job. It helps make certain excess pressure does not develop inside the water storage tank, or in even more easy terms, it makes sure the water heater does not blow up. As the photo shows, it has a lever or little handle on it. All you have to do is raise it part method then let go of it. Ideally, it snapped back to its closed position quickly. If it is working correctly, a little water can be heard going into the drain pipe below the lever you just lifted and you maybe heard some pressure being released. If none of these things have occurred during the test, the valve will have to be changed.

Carry out a Mimi Water Heater Tank Flush

By nature, rust and rust will occur inside the water tank thanks to the chemical reactions taking place with all the elements inside that are needed to heat the water. We will not get too technical right here, but it is easy to assist avoid this process by doing a flush or draining of all or a portion of the water in the storage tank.

For simply a tiny flush, position a pail under the drain valve below the tank. Open the drain valve and fill up the bucket with water. Drain at least a couple of gallons of water in total. Let the water sit in the container for a couple of minutes to settle and analyze if there is much that settles to the bottom of the bucket. If there is, if the water heater has not been drained for a very long time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature dial down and may wish to let the water cool off for about an hour initially so it is not too hot while draining it. Also, it would be simpler to connect a hose to the drain valve and let the water go outside rather of utilizing buckets.

If the water looks relatively clean and clear from the mini test you should be all set. When the water heater has an excessive amount of sediment inside of it, it can make loud popping sounds and it lowers its efficiency too.

Though water heaters are fairly upkeep free and easy to operate, any time you feel the smallest bit awkward or are not sure of what to do, it is always best to have a plumbing expert help with the circumstance.

Water Heater Repair Boise